Loading... Please wait...

Atkins 30 Hour Clock Movement

Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5
  • Image 6
  • Image 7
  • Image 8
  • Image 9
  • Image 10
atkins 30 hr
$16.00 (Fixed shipping cost)
Current Stock:

 Product Description

  Atkins 1850's 30 Hour OG Clock Movement



If your serious about replacing your worn movement with a high quality rebuilt movement consider one of ours. Every pivot, lever and tooth is inspected for defects and repaired or replaced if needed providing you with a movement as close to factory new as you can find anywhere.


Our movements are simply the best rebuilt movements you will find anywhere period! We take NO shortcuts on the overhaul process and have a extensive used parts inventory should a defective part have to be replaced. 


 The 30 hour Atkins  movement pictured was just rebuilt by us and shows where new Bergeon bronze bushings where installed, see picture with the red circles.


Prior to installing new Begeon bronze bushing all pivots where polished using a Rollimat pivot polisher, a tool specifically designed for polishing pivots of all  the defects. When finished every pivot is perfectly round again and has a mirror like finish, a thing of beauty.


We then assemble and test the movement for at least one week prior to oiling the pivots with the best synthetic clock oil. We have always tested our movements without oil for at least a week so not to hide and potential binding problems.


Your newly overhauled movement will provide many years of dependable service, all you have to do is wind it up and enjoy.


 See picture with red circles indicating new bronze bushings on the back and front plate.

New winding cord has been installed on both the time and strike.

Remember ALWAYS have the weights attached before winding.


 See picture with the yellow arrow which shows where the pin or nail like thing that holds the seat board inside the case, these are on both sides of the seat board and must be removed from your seat board before removing it. Normally these can removed by pushing them out from inside the round circle located on top of the seat board. 

  Strikes the hours on the hour

See pictures for distances for the winding arbors and center shaft (where the hands attach)  to the center shaft.

 Comes as pictured. 

 Find Similar Products by Category

Vendors Other Products

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...

What's News


Copyright 2019 Back In Time Clock Parts & Restoration. All Rights Reserved.
Sitemap | BigCommerce Premium Themes by PSDCenter

Click the button below to add the Atkins 30 Hour Clock Movement to your wish list.